Scheduled Reports

Authorized users can access the Scheduled Reports properties by clicking on the Administration > Settings > Properties link, then clicking on the Scheduled Reports category heading.

To configure the settings, enable (select) or disable (deselect) the options, enter any required information, and click Save at the bottom of the page. Changes affect users the next time they log in to the application or module.

Click Reset to erase new or updated entries and reset them as they were after the last submit was done.

Option/Field

Description

Blocked Hours: Non-Registry Clients (0-23, comma-separated)

Enter whole numbers separated by commas to represent the available hours for users to schedule reports to run. This setting only affects non-Registry Client users.

Blocked Hours: Registry-Wide (0-23, comma-separated)

Enter whole numbers separated by commas to represent the available hours for users to schedule reports to run. This setting reflects all of the system's downtimes.

Email Text

Enter the text that appears in the body of UFM messages (emails).

IWeb Address

Enter the IWeb root location URL for UFM reports to run. This should be the location of the Tomcat server.

NOTE: It is very important that this URL be entered. Not having a URL in this field can cause reports to take more than 10 hours longer than normal to run.

Output Folder

Enter the file path for the location on the hard drive where the generated reports are to be stored.

Proxy Server Address

Enter the proxy server URL address, if applicable.

Reply-to Email Address

Enter the reply-to (From) email address for the scheduled reports.

Zip Report Output Before Emailing

Select this option to zip the report output before attaching it to the email.

Scheduled Reports Properties